Hydraulic Car Parking System: Maintenance Tips for Long-Term Efficiency

Hydraulic three-dimensional parking system of small area, high space utilization, urbanization of the rapid development of land resources become increasingly scarce gradually is to solve the urban parking problem for an important way. However, scientific and reasonable maintenance management is the key to long-term and efficient operation of the hydraulic three-dimensional garage system. This article discusses the operation and maintenance points of hydraulic three-dimensional parking system from the aspect of hydraulic system, mechanical structure, electrical equipment and daily management, providing reference for relevant practitioners.

One that stood out to me was hydraulic system maintenance.

Hydraulic system is the core part of hydraulic three-dimensional parking system, its operating conditions directly affect the performance of the entire system.

1.1 General replacement & test: The Hydraulic oil needs to be replaced from time to time + Test for Safety.

Hydraulic oil can be called the "blood" of hydraulic system, and the quality of hydraulic oil has become a direct proportion with hydraulic system high operating efficiency. Ígner te sà dilyan nang six month bes, test hàn hydraulic oil (fluidà) viscosity, acid value aniì contamination d ÿè inik... If the hydraulic oil is found to be deteriorated or polluted, it should be replaced in time. The hydraulic oil must be used in both of these aspects, and residual impurities must not have a bad effect on the new oil.

1.2 Hydraulic parts to be checked and maintained

Check the tightness and wear of hydraulic pumps, hydraulic cylinders, control valves and other equipment regularly. It limits wear because when the seal reaches an older state or wears out, the seal must be replaced immediately to avoid leakage of hydraulic oil from reaching a significant level, or loss of system pressure. The hydraulic pipeline must also regularly check whether there is cracks, corrosion or loosening, and to ensure that the connection is tight without leakage.

3.1 Monitoring and adjusting system pressure

Hydraulic system working pressure should be controlled within the design value, too high or too low pressure can work in the system. You are advised against using a pressure gauge to check the system pressure every month and to adjust the pressure as per device instructions. The pressure is abnormal Data until October 2023, which will cause pressure damage to the device, causing hysteresis, again causing the hardware device to be damaged.

Mechanical structure up-keep

A hydraulic three-dimensional parking system mechanical structure includes vehicle plate, guide rail, chain and other components, and its stability and reliability are the prerequisite for the long-term operation of the system.

2.1 Regular Check of Vehicle Board

And the surface of the carrier plate that carries the vehicle on the carrier plate should also be regularly checked for cracks, deformation or corrosion. If the problem is found, it must be repaired or replaced in a manner that securely ensures the park parking is secure. Proper tightening of the connection bolts of the vehicle plate can effectively avoid operation loosening and instability.

Rail & chain maintenance and lubrication

In mechanical structure, the moving parts are guide rail and chain, and the lubrication state of guide rail and chain directly affects the efficiency of the system. Recommended every 3 months to apply special lubricants to reduce friction and wear to the guide rail and chain. If the guide rail is deformed or offset, the chain is stretched or broken, should timely adjustment or replacement.

Mechanical structure preventive maintenance

Mechanical structures are exposed to the environment for long periods and highly susceptible to dust and humidity. The mechanical structure which would need cleaning once every month where dust and debris would need to be removed. For metal parts, we can also apply anti-rust oil or anti-rust paint to the metal parts to prevent rust from reducing its service life.

Maintaining electrical machinery components

For hydraulic three-dimensional parking system, the electrical is the control center of the whole plant, and its normal operation is the only guarantee for the system to operate efficiently.

Periodic checking of electrical parts 3.

Control cabinets, sensors, motors and other electrical components, the connection is firm, insulation is good, the external wiring and bare conductors are not up, if there is damage, insulation is damaged and Wait in time to replace the cable. This is actually to serve two purposes; one is to prevent the sensor from working properly, so that its sensitivity and accuracy will not cause the whole system judged incorrectly led to failure.

3.2 Updating control system software

Modern hydraulic three-dimensional parking system uses intelligent control system more, its software should regularly upgrade to mend loophole, optimize performance. You also have to contact the device all provider every 6 months, ensure that you now have the updated software application version and get upgraded. And regularly back up system data to prevent data loss from impacting the operation of the system.

3.3 Emergency Power Supply Maintenance

Hydraulic stereo parking system generally have an emergency power supply, the sudden power failure can still be controlled. Submission: on the Other Hand, When off setting The Emergency Power Supply Charge and Discharge Test You need to Follow the laws of time set every 3 months to make Sure that it is Power and Specification of the power supply energy is Stable.

Iv. Daily management and personnel training

Effective daily management and professional personnel training are the predecessor of excellent guarantee hydraulic three-dimensional parking system long-term efficient operation.

4.1 Have a maintenance system in place

A clear and detailed maintenance work order can clarify the date, content and person responsible for each maintenance work. To create tracking device running files related to time, content and problems found during each maintenance and its analysis.

4.2 Enhance operator training

However, it requires you to have a good understanding of device structure, principle and operating rules to avoid misoperation damage. In order to enhance the professional skills and emergency treatment capabilities of the operators, it is recommended to carry out training regularly.

4.3 Regularly review security practices

During its operation, hydraulic vertical parking systems may undergo rapid failure or safety accident. Every six months she urges to conduct a safety drill to simulate unexpected situations such as equipment failures and power outages for operators to develop their emergency response ability, to ensure the system operates safely.

Conclusion

Scientific rationality maintenance management is one of important features of1both so central and effective long-term operation for the hydraulic three-dimensional parking system, and modern urban parking management facility. Regular inspection and maintenance of hydraulic system, mechanical structure and electrical equipment, and improvement of daily management and employee training can effectively extend the service life of the equipment, reduce the fault rate, and provide effective guarantee for urban parking lot management. The maintenance recommendations provided in this paper are expected to provide references for relevant staff and benefit the sustainable development of hydraulic stereoscopic parking system.